Here is a request from one of our backers, a beautiful Warhammer piece from Thingiverse:
https://www.thingiverse.com/thing:906266
We try to print this straight up and do as little support as possible instead of the usual 45 degrees rotate with lots of support. We did not realize the bottom is hollow by design, so that adds an interesting element to printing.
It was printed with 50-micron layer heigh over 4 hours:
Here are the high-resolution results: download here
We did not realize bottom was hollowed out by design and we were able to print fine. We will remember to check the bottom of the base next time.
