Magneto X Update from SMRRF 2023, Live Stream Announcement and More

Hi Magneto X Community,

Greetings from SMRRF 2023 in Oxford, UK! I'm here battling the tail end of a flu, but I didn't want to miss the chance to share an update on Magneto X.
I know many of you were eagerly anticipating seeing Magneto X in action at the event. That was our plan too. Unfortunately, we faced some unexpected challenges with the electrical setup in the older building where the event is being held. This issue affected the load cell sensor on the extruder. While trying to fix it, I accidentally shorted the communication board. We had spare extruders, but not spare boards, which meant we couldn't print at the event.

I understand how disappointing this is for you all, and I share your feelings. But let's focus on what we can do moving forward:

1) Live Stream Session: I'll be hosting a live stream next week, where I'll be available to answer your questions while we showcase the printer in action. Mark your calendars for December 8th, 2023.

2) Uncut Printing Video: Before the live stream, we'll release a full, unedited video of the printer working, so you can see it for yourself.

3) Heading Back: I'm traveling back to Hong Kong tonight, so there might be a bit of a delay in communication.

I apologize for not being able to communicate sooner due to the busy nature of the show and dealing with my flu. Thank you for your understanding and continued support. We're all in this together, and I'm committed to keeping you informed and engaged.

Warm regards,
Mark Peng